LEARN / OCEAN WAVES / CHAPTER 18

Spectral Energy Budgets

Full original scientific lesson and experiments, reorganized into a dedicated chapter.

Original physics and annotationsInteractive scientific demonstrationsScientific teaching examples

Scientific scope: This lesson retains the original scientific explanations, diagrams, equations and interactive demonstrations. All numerical examples are educational and subject to their stated assumptions; they are not independently field-validated engineering design tools or operational forecasts.

CHAPTER 18 / GAINS, LOSSES AND TRANSFERS

Why a spectrum changes.

Propagation moves wave energy from one place to another. Source terms describe local input, dissipation and exchanges between spectral components. Keeping these roles separate makes the spectrum easier to interpret—and the model easier to check.

The local spectral budget
ProcessPhysical interpretationEffect on the spectrum
Wind inputAtmospheric pressure and stress transfer energy to waves.Depends on wind relative to wave direction and speed; a fixed wind does not amplify every bin equally.
WhitecappingBreaking of wind waves dissipates organized wave energy.A modelled loss with formulation-dependent spectral distribution.
Bottom frictionOscillatory near-bed motion loses energy through boundary-layer processes.Depends on depth, wave motion and seabed properties; often important for components that feel the bed.
Depth-induced breakingFinite depth limits the waves that can propagate without breaking.A sea-state dissipation closure; clipping every wave to one height is not an equivalent spectral model.
Nonlinear interactionsWave components exchange energy through nonlinear dynamics.Quadruplet interactions are central in deep water; triad interactions become important in shallow water. They redistribute energy rather than act as an external energy supply.

Inspect a transparent bookkeeping budget.

Toggle prescribed source terms and compare the initial spectrum with one short explicit update. Rates are illustrative fixed numbers, chosen to expose signs and conservation. They are not wind-growth, friction or breaking parameterizations and cannot predict a real sea state.

Six bins of width Δf = 0.02 Hz. Bars show variance density S = v/Δf in m²/Hz. Blue: initial; coral: updated. Source rates remain fixed during this single update.

Include source terms
Equations, units and the conservative transfer

∂S/∂t = Qwind + Qwhite + Qbottom + Qbreak + Qnl

vᵢ,new = vᵢ,old + Δt qᵢ,   qᵢ = Qᵢ Δf

Δm₀ = Δt Σqᵢ,   E = ρg m₀

S has units m²/Hz and Q has units m²/(Hz s). The table reports bin-integrated q in m²/s. Negative rates are losses. Integrating a physical energy-source density instead would require the factor ρg. This lesson uses variance consistently.

The redistribution example adds 0.00016 m²/s at 0.08 Hz and 0.00024 m²/s at 0.12 Hz while removing 0.00040 m²/s at 0.10 Hz. Their sum is zero. Their sum after division by ω is also zero, so the discrete variance-based action proxy Σvᵢ/ωᵢ is conserved. This is a designed accounting example, not a resonant quartet solution: no wavenumber resonance or interaction coefficient is evaluated. Do not infer that all nonlinear processes conserve wave action; the distinction between triad and quartet interactions matters.

All selectable combinations remain nonnegative over the offered time range. A production model must also control stability, positivity and source-term stiffness. Reducing a time step does not correct an inappropriate physical parameterization.

A budget can balance without being accurate.

Conservation tests identify numerical and bookkeeping errors. They cannot establish that a wind-input or dissipation closure represents the observed sea. Different terms may compensate for one another and produce a plausible significant wave height while the peak period, direction or high-frequency tail is wrong. Compare the spectrum and its evolution, not only one bulk number.