A turn changes
the height story.
A wave slows as it enters shallower water, but slowing alone does not tell us its new height. The direction of energy travel matters too. Compare two approaches to the same straight coast.
Look from the side. Then look from above.
Both views show the selected oblique-incidence case (the coral curve in the comparison chart). Fixed beach slope: 1:80. Adjust the shared conditions ↓. The same dark dashed line marks your selected depth.
A · Profile view — a cross-shore slice
B · Bird’s-eye view — the same field from above
Blue: normal incidence, shoaling alone · Coral: selected oblique incidence, shoaling and refraction · Each curve ends at its own estimated breaking onset. Depth decreases to the right on a logarithmic axis; this is not distance offshore.
What exactly are we comparing?
Both cases start with the same wave height and period at 50 m depth. The blue case approaches the depth contours at right angles. The coral case starts at your selected angle. They therefore begin with equal energy density, but different energy flux towards shore.
For these parallel contours, turning towards the normal spreads neighbouring ray paths farther apart when their spacing is measured perpendicular to the rays. The resulting refraction factor is at most one. It reduces the height relative to the normal-incidence calculation at the same depth.
This does not mean refraction always lowers waves. A shoal or headland can concentrate ray paths and increase local height. The parallel-contour model here does not represent that geometry.
Try a controlled comparison.
- Choose 0°. The curves should coincide: there is no directional correction.
- Choose 40°, then 65°. Inspect 5 m depth and compare both heights.
- Increase the input height. Observe where each curve stops; the same breaking rule is applied separately to each case.
Check your understanding
Can the combined wave still grow above its input height? Yes. A sufficiently large shoaling factor can outweigh the reduction associated with refraction.
Does the coral curve lose energy through friction? No. This comparison contains no dissipation before breaking. Geometry and group speed account for its height change.
Connect both processes to the equation
For this stationary, alongshore-uniform coast without currents or energy losses, the shoreward energy flux per unit alongshore width is conserved:
Ks = √(Cg,ref/Cg) represents the group-speed change. Kr = √(cos θref/cos θ) represents refraction here. Angles are measured from the shore-normal. Both factors refer to 50 m, which need not be deep water.
Model limits and breaking markers
Small-amplitude regular waves, gently varying parallel contours, no reflection, diffraction, current, wind input or bottom friction. This is a comparison of two idealised incident directions, not a forecast of an irregular sea.
Each curve stops when its height first reaches the smaller of 0.78h and 0.142L tanh(kh). These are approximate limits, not a calibrated surf-zone model. Nonlinear shape changes can matter before this boundary. No post-breaking height is calculated. If no crossing occurs above 0.5 m, the chart simply ends at the minimum depth shown.
Scientific basis and attribution
The energy-flux formulation is checked against Reeve, Chadwick & Fleming (2018), Coastal Engineering, §2.3.3, printed pp. 34–35, equation 2.20; Sorensen (2006), Basic Coastal Engineering, §4.2; and Holthuijsen (2007), Waves in Oceanic and Coastal Waters, §§7.3.1–7.3.2.
Text, code and chart are original. The equations express established wave theory; the source sections above explain their derivation. Free background overview: Coastal Wiki — Waves ↗.